Created on:2025-09-11

safety precautions for the use of tractors

safety precautions for the use of tractors

Maintenance Precautions

check the engine cooling system for frostbite, especially for cars that do not drain water or antifreeze before winter. Carefully check the engine body for signs of frost cracking, such as water blockage, water drain switch, oil radiator, etc.

Check whether the circuits of tractor starting, lighting and instrument are normal, and the insulation parts of all electrical accessories shall be free of leakage, short circuit, etc.

When the battery is low, it should be charged with one tenth of the rated current of the battery. When charging the lead-acid battery, the electrolyte level is flush with the engraved line or 10~15mm higher than the separator. Open the filling plug to prevent the outlet from being blocked and the battery explodes due to excessive air pressure. After charging is completed, the single battery voltage should be around 13 volts.

Before starting, the main and auxiliary transmission handles should be in the "empty", "down", "middle" or "separated" position, and the hydraulic power device should be in the "middle" position. When starting, the speed needs to be low and then high, and gradually increase the power speed. At the same time, observe the instrument, listen carefully to the sound, and check for water leakage, oil leakage, and air leakage. If there is any abnormality, stop the machine first and then check and troubleshoot.

When the engine is difficult to start, in order to protect the battery, it is not allowed to start continuously and frequently, and the restart must ensure sufficient time interval. When it is necessary to use the glow plug to start the engine, the warm-up time should be determined according to the temperature.

Check the lubricating oil of the gearbox, front axle, and end transmission one by one; check whether the lithium-based grease (worm gear mechanical steering machine) or the hydraulic oil in the hydraulic oil tank (hydraulic steering machine) is sufficient; check the hydraulic system Whether the hydraulic oil is sufficient.

Check the clearance between the left and right steering wheels, and observe the clearance between the tie rod ball drive and the pin shaft of the oil cylinder (in the direction of the hydraulic oil cylinder). If the clearance is too large, replace the tie rod ball and the pin shaft of the oil cylinder. After replacing the ball head and pin shaft, check the toe. The toe of the four-wheel drive is 0~4mm, and the toe of the two-wheel drive is 5~10mm.

Check the gap between the clutch pedal and the release bearing and the release lever to ensure thorough and flexible separation without jamming. When the pedal stroke is 4/5, the shift position can be engaged without abnormal noise. If the clutch has been used for too long, it is necessary to disassemble and check the friction plate and release bearing. If it exceeds the limit, it needs to be replaced; if the wear is not large, add grease to the release bearing and then assemble it according to the standard.

Check the brake fluid level and pedal stroke of the brake. The first foot of the brake pedal can be pressed to death at one time, and the second foot cannot be pressed continuously. The return is normal and there is no seizure. The heights of the left and right brake pedals should be synchronized.

use precautions

1. Road traffic section

The transfer of agricultural machinery on the way to comply with traffic rules, obey the command of the traffic police, and consciously maintain traffic order. Do not speeding and fatigue driving, do not illegally carry people, and pay attention to maintaining a safe driving distance.

should follow the principle of "four slow and four slow" when driving on icy and snowy roads, that is, slow refueling, slow starting, slow steering, slow turning, and slow braking when necessary to increase the safety distance and prevent rear-end collisions. In the case of icy roads or steep downhill, engine traction should be used as much as possible for braking. When the ground is slippery, you can start in second gear to prevent slipping.

pay attention to driving "pre-judgment". When driving in rainy and snowy weather, the distance to the car in front should be kept within a relatively safe range, so that it can brake in time in case of emergency. When turning, especially the curve with large curvature, you should slow down in advance and pay attention to the surrounding environment to avoid accidents caused by blocked sight. If you need to stop temporarily on the rainy and snowy road, you should choose the place where the sun is rising and the wind is sheltered, and take appropriate protective measures, such as inserting triangular wood or stones under the wheels of agricultural machinery to prevent sliding.

care to avoid glare. After the snow is sunny, the sun is often dazzling, and protective glasses can be worn to ensure that the driver can find the road conditions in time during driving. If agricultural machinery is caught in rain, snow or muddy ruts, causing wheels to slip, try to reduce tire pressure to increase adhesion in order to get out of trouble.

Agricultural Production

operation, carefully investigate the field operation site, remove obstacles, and set up obvious signs at obstacles and dangers such as telephone poles, sundries, and manhole covers. Personnel unrelated to the operation are prohibited from entering the operation site. It is strictly forbidden to drive and operate agricultural machinery after drinking or taking drugs that affect judgment. The driving operator should set a contact signal with the auxiliary operator.

Tractor is not allowed to use the method of loosening the clutch to start or rush over obstacles during driving and operation. When hanging farm tools or trailers, ensure reliable connection and install safety chain.

Strictly follow the safety operation procedures of the tractor, and pay attention to the safety when turning or reversing the ground. Avoid touching ridges, canals, trees or other obstacles when turning or working on the ground. When reversing, you should find out the rear situation and confirm the safety before reversing.

be selected according to the terrain characteristics, dry and wet conditions, etc. During the operation, it is forbidden to use hands, feet or tools to remove soil and weeds on agricultural tools; it is forbidden to troubleshoot without shutdown.

When drivers and agricultural machinery operators work, it is forbidden to wear slippers and clothes that are loose or cannot be buckled at the cuffs, so as to avoid danger during operation. The driver must have the driving operation qualification. When driving agricultural machinery, he must carry a driver's license and driving license, and shall not hand over the machine to a person without a driver's license.

It is strictly forbidden to carry people in violation of regulations, the cab shall not be overloaded, and articles that hinder operation, affect sight and have potential safety hazards shall not be placed. Manning is prohibited on fenders, traction frames and suspended farm tools.

Source: Yichun Agriculture and Rural Bureau

Website: https://mp.weixin.qq.com/s/Ou9DlP1WBISpMmoNKuP3sA


Agricultural machinery operation

Created on:2025-09-11

safety precautions for the use of tractors

safety precautions for the use of tractors

Maintenance Precautions

check the engine cooling system for frostbite, especially for cars that do not drain water or antifreeze before winter. Carefully check the engine body for signs of frost cracking, such as water blockage, water drain switch, oil radiator, etc.

Check whether the circuits of tractor starting, lighting and instrument are normal, and the insulation parts of all electrical accessories shall be free of leakage, short circuit, etc.

When the battery is low, it should be charged with one tenth of the rated current of the battery. When charging the lead-acid battery, the electrolyte level is flush with the engraved line or 10~15mm higher than the separator. Open the filling plug to prevent the outlet from being blocked and the battery explodes due to excessive air pressure. After charging is completed, the single battery voltage should be around 13 volts.

Before starting, the main and auxiliary transmission handles should be in the "empty", "down", "middle" or "separated" position, and the hydraulic power device should be in the "middle" position. When starting, the speed needs to be low and then high, and gradually increase the power speed. At the same time, observe the instrument, listen carefully to the sound, and check for water leakage, oil leakage, and air leakage. If there is any abnormality, stop the machine first and then check and troubleshoot.

When the engine is difficult to start, in order to protect the battery, it is not allowed to start continuously and frequently, and the restart must ensure sufficient time interval. When it is necessary to use the glow plug to start the engine, the warm-up time should be determined according to the temperature.

Check the lubricating oil of the gearbox, front axle, and end transmission one by one; check whether the lithium-based grease (worm gear mechanical steering machine) or the hydraulic oil in the hydraulic oil tank (hydraulic steering machine) is sufficient; check the hydraulic system Whether the hydraulic oil is sufficient.

Check the clearance between the left and right steering wheels, and observe the clearance between the tie rod ball drive and the pin shaft of the oil cylinder (in the direction of the hydraulic oil cylinder). If the clearance is too large, replace the tie rod ball and the pin shaft of the oil cylinder. After replacing the ball head and pin shaft, check the toe. The toe of the four-wheel drive is 0~4mm, and the toe of the two-wheel drive is 5~10mm.

Check the gap between the clutch pedal and the release bearing and the release lever to ensure thorough and flexible separation without jamming. When the pedal stroke is 4/5, the shift position can be engaged without abnormal noise. If the clutch has been used for too long, it is necessary to disassemble and check the friction plate and release bearing. If it exceeds the limit, it needs to be replaced; if the wear is not large, add grease to the release bearing and then assemble it according to the standard.

Check the brake fluid level and pedal stroke of the brake. The first foot of the brake pedal can be pressed to death at one time, and the second foot cannot be pressed continuously. The return is normal and there is no seizure. The heights of the left and right brake pedals should be synchronized.

use precautions

1. Road traffic section

The transfer of agricultural machinery on the way to comply with traffic rules, obey the command of the traffic police, and consciously maintain traffic order. Do not speeding and fatigue driving, do not illegally carry people, and pay attention to maintaining a safe driving distance.

should follow the principle of "four slow and four slow" when driving on icy and snowy roads, that is, slow refueling, slow starting, slow steering, slow turning, and slow braking when necessary to increase the safety distance and prevent rear-end collisions. In the case of icy roads or steep downhill, engine traction should be used as much as possible for braking. When the ground is slippery, you can start in second gear to prevent slipping.

pay attention to driving "pre-judgment". When driving in rainy and snowy weather, the distance to the car in front should be kept within a relatively safe range, so that it can brake in time in case of emergency. When turning, especially the curve with large curvature, you should slow down in advance and pay attention to the surrounding environment to avoid accidents caused by blocked sight. If you need to stop temporarily on the rainy and snowy road, you should choose the place where the sun is rising and the wind is sheltered, and take appropriate protective measures, such as inserting triangular wood or stones under the wheels of agricultural machinery to prevent sliding.

care to avoid glare. After the snow is sunny, the sun is often dazzling, and protective glasses can be worn to ensure that the driver can find the road conditions in time during driving. If agricultural machinery is caught in rain, snow or muddy ruts, causing wheels to slip, try to reduce tire pressure to increase adhesion in order to get out of trouble.

Agricultural Production

operation, carefully investigate the field operation site, remove obstacles, and set up obvious signs at obstacles and dangers such as telephone poles, sundries, and manhole covers. Personnel unrelated to the operation are prohibited from entering the operation site. It is strictly forbidden to drive and operate agricultural machinery after drinking or taking drugs that affect judgment. The driving operator should set a contact signal with the auxiliary operator.

Tractor is not allowed to use the method of loosening the clutch to start or rush over obstacles during driving and operation. When hanging farm tools or trailers, ensure reliable connection and install safety chain.

Strictly follow the safety operation procedures of the tractor, and pay attention to the safety when turning or reversing the ground. Avoid touching ridges, canals, trees or other obstacles when turning or working on the ground. When reversing, you should find out the rear situation and confirm the safety before reversing.

be selected according to the terrain characteristics, dry and wet conditions, etc. During the operation, it is forbidden to use hands, feet or tools to remove soil and weeds on agricultural tools; it is forbidden to troubleshoot without shutdown.

When drivers and agricultural machinery operators work, it is forbidden to wear slippers and clothes that are loose or cannot be buckled at the cuffs, so as to avoid danger during operation. The driver must have the driving operation qualification. When driving agricultural machinery, he must carry a driver's license and driving license, and shall not hand over the machine to a person without a driver's license.

It is strictly forbidden to carry people in violation of regulations, the cab shall not be overloaded, and articles that hinder operation, affect sight and have potential safety hazards shall not be placed. Manning is prohibited on fenders, traction frames and suspended farm tools.

Source: Yichun Agriculture and Rural Bureau

Website: https://mp.weixin.qq.com/s/Ou9DlP1WBISpMmoNKuP3sA