Rotary Tiller Maintenance Points
rotary tillerMaintenance Points
Maintenance before (I) operation
1. Check the transmission box. Check the amount of gear oil in the transmission box. If it is lower than the oil surface line, add the same type of gear oil; check the gap between the gears, especially the meshing gap of the bevel gear. If the gap is too large or too small, it will cause failure; check the output spline of the transmission box The gap between the shaft and the shaft sleeve of the knife shaft should be replaced in complete sets if the wear is serious.
2. Check the knife. Check the oil seals at both ends of the knife shaft, as well as the knife shaft, knife seat and blade. If there is any damage, replace the old one with a new one. When replacing the blade, the blade fixing bolts should be tightened regularly in the direction of the double helix. When replacing rotating parts such as blades, the tractor must be turned off.
3. Check whether the rotary blade is installed reverses and whether the fixing bolts and universal joint lock pin are firm, and can be used only after confirmation.
(II) operation
1. Before the tractor starts, the clutch handle of the rotary tiller should be turned to the separation position. In order to engage the power in the lifting state, the unit can start only after the rotary tiller reaches the predetermined speed, and slowly lower the rotary tiller to make the rotary tiller into the soil. It is forbidden to start directly under the condition that the rotary tiller knife is buried to prevent the rotary tiller knife and related parts from being damaged. It is strictly forbidden to descend the rotary tiller rapidly, and it is strictly forbidden to reverse and turn after the rotary tiller knife is buried.
2. During operation, if the knife shaft is too much wrapped with grass, stop and clean it in time to avoid increasing the load of machines and tools.
(III) safety operation tips
1. When the power is not cut off when the ground is turned, the rotary tiller shall not be raised too high, the transmission angle at both ends of the universal joint shall not exceed 30 degrees, and the engine speed shall be appropriately reduced.
2. When transferring plots or walking at a long distance, the power of the rotary tiller should be cut off and locked after rising to the highest position.
3. When the rotary tiller is running, people are strictly prohibited from approaching the rotating parts, and no one is allowed behind the rotary tiller to prevent the blade from throwing out and hurting people.
4. During rotary tillage, the tractor and suspension parts are not allowed to take people to prevent accidental injury by the rotary tiller.
Source: Public Number Sangma Words Liangzhou
Website: https://mp.weixin.qq.com/s/ZTSndPLw1mcZo3Bfs2hvUA
