Combine Safety Precautions
Combine Safety Precautions
Precautions for (I) maintenance 1. Start the engine, idling for 10~15 minutes, and observe whether there is any abnormality. If there is any abnormality, stop the engine for inspection and elimination. 2. Check the bolt tightening of the roller, fan, header, screen box drive mechanism and other parts with high speed, heavy vibration and heavy load, and the sprocket and bearing with high speed, and adjust as required. 3. Check whether each rotating part rotates flexibly; adjust the tension of chain and belt. 4. Check the harvesting mechanism. Check whether the cutter blade is intact and firm, whether the gap is reasonable, whether the center line of the moving blade and the blade protector is coincident, and adjust the fastening as required; adjust the height of the reel and the sagging amount of the holding claw according to the operation requirements. 5. Check the threshing and cleaning device. Adjust the threshing clearance and cleaning fan air volume according to the operation requirements. Check the wear of the grass cutter, vibrating screen and front bearing, louver sieve strip, etc. and replace them as necessary. 6. Check the technical status of the clutch and brake device to ensure reliability and flexibility. Precautions for (II) use 1. When passing through dams, bridges and culverts, the load capacity, road width, space width and height should be confirmed first. 2. Before operation, carefully investigate the field operation site, remove obstacles, and set up obvious signs at obstacles and dangers such as telegraph poles, sundries, manhole covers, etc. Personnel unrelated to the operation are prohibited from entering the operation site. The driving operator shall set the contact signal with the assistant operator. 3. It is forbidden to operate and maintain the harvester after drinking, taking medicine or under fatigue. 4. Operate in strict accordance with the safety operation procedures of the combine harvester, and pay attention to the safety when turning or reversing the ground. When turning the ground or working on the ground, avoid the header touching the ridge, canal, trees or other obstacles. When reversing, it is necessary to find out the situation behind the combine and confirm the safety before reversing. 5. According to the characteristics of the terrain, dry and wet conditions, such as the selection of harvesting speed. In case of wrapping grass on the header, threshing, separating and straw chopping devices, or blockage of operating parts such as cutters and rollers, clean up after shutdown. It is forbidden to put your hand into the grain outlet or the grass outlet to remove the blockage. When unloading grain, it is not allowed to use hands, feet or iron tools to reach into the granary to push or clean the grain. The grain receiving personnel shall not go up or down the grain receiving table during the harvest. 6. Be sure to shut down the engine and remove the key when cleaning, overhauling, refueling and when the operator leaves the cab. When two people repair the harvester together, it is strictly forbidden for another person to rotate the rotating parts without permission. 7. When lifting the header, opening the granary, threshing roller and other operating mechanisms for maintenance, cleaning and adjustment, please be sure to lock the safety lock to ensure that each mechanism will not fall or close on its own and cause personal injury. 8. It is strictly prohibited to smoke in the rice field. It is necessary to prevent fire accidents caused by poor contact and short circuit of electrical circuits and accumulation of grass cuttings around the exhaust pipe of the engine.
Source: Yichun Agriculture and Rural Bureau
Website: https://mp.weixin.qq.com/s/Ou9DlP1WBISpMmoNKuP3sA
