Straw Crushing and Returning Machine
Straw Crushing and Returning Machine
1. Maintenance before operation
(1) Check and tighten the connecting bolts and nuts.
(2) Check the latches and cotter pins for defects, and supplement or replace them if necessary.
(3) Add grease, and the transmission shaft telescopic sleeve should be coated with grease.
(4) Check the sealing condition of the gearbox. The static joint should not leak oil, and the dynamic joint should not drip or leak oil. If oil leaks, replace the paper pad or oil seal.
(5) check the gearbox lubricating oil level, when not enough to add. Check whether the breathing hole on the gear box is unblocked. If there is any blockage, it should be cleared in time. Check whether the oil drain plug bolt is loose and tighten the seal.
(6) Check whether the knife shaft flick (hammer claw) is defective and make up in time. Blades shall be replaced in groups. When replacing the blade, two sets of radially adjacent blades should be replaced symmetrically, and the weight difference of each set of blades should be less than 10 grams.
(7) Remove the soil and entangled objects on the flick knife, knife shaft and fixed blade.
(8) Check the temperature rise of each bearing. If the temperature rise is too fast or too high, it is caused by excessive bearing clearance or lack of lubricating oil. Adjust the clearance or add lubricating oil for lubrication in time.
2. Maintenance in operation
(1) Check and adjust the belt tension at any time, and clean up the cohesive soil layer on the inner wall of the casing in time. When abnormal sound and vibration are found, stop the machine immediately for inspection.
(2) Adjust stubble height. To adjust the depth limit roll, a row of adjustment holes are reserved on the left and right side plates of the frame. Different fixing positions will result in different stubble heights. Both sides should be adjusted synchronously during adjustment. Pay attention to the minimum stubble height so that the cutting edge of the flick (hammer claw) is not in the soil, otherwise it will accelerate the wear of the flick (hammer claw), reduce the crushing effect and increase the load of the tractor.
3. Safety operation tips
(1) When the straw crushing and returning machine is running, it is strictly prohibited for the human body to approach the rotating part, and no one is allowed on and behind the machine to prevent casualties.
(2) When turning or reversing, the straw crushing and returning machine must be lifted and the power cut off. It is strictly prohibited to lift and release the straw.
(3) If there is abnormal noise or vibration during operation, stop the vehicle immediately for inspection, and continue to work after troubleshooting.
(4) When overhauling and cleaning up sundries of machines and tools, the tractor must be turned off, and the machines and tools must be grounded and stabilized to prevent them from hurting people.
Source: Maanshan Agricultural and Rural Bureau
Website: https://mp.weixin.qq.com/s/6r0m5JYSDKD00f9g1sHUTw
